GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 Please respond! Injecting question.
|
| Author | Topic: Please respond! Injecting question. | ||
|
Cool Novice 
Posts: 23 |
While reading a few injection sites on the internet, I noticed something I found a little screwed up...all sites insist on you having your solution in an airtight sterile vial. Then they tell you to fill up your syringe w/ some air, inject it into the vial, inject the air, and then pull the solution into the syringe. WTF!!!! I thought the entire purpose of having an airtight vial was to keep air (which may have bacteria in it) out. If you do their procedures you just completely undid that. So I guess my question is, is it really necessary to have an airtight bottle? I was thinking of just using some super glue remover (aka, acetone) bottle, emptying it out, and then putting it low heat on the stove till the acetone cooks off and then calling this a sterile bottle, putting some wesson oil and fina in it, resterilizing it on the stove in a hot water bath, and then opening it each time for injections. Obviously I will have to open the bottle for each injection, but according to my logic above this should not be a problem. Am I right or did I completely fuck over something important? Thanks!     | ||
|
Cool Novice
Posts: 21 |
You can do what you want, but your idea is something I would never try. | ||
|
Pro Bodybuilder 
Posts: 358 |
You have a point on the injection of air into the vial. But I wouldn't recommend your ideal on fina, at all. Just order a kit. You can get a kit over at renagade or from animal both are a better ideal. | ||
|
Novice 
Posts: 7 |
I'm goin with physics. A hell of a lot less air will touch the juice by having a small amount of air in the needle than the amount of times you open the bottle to get it. |
All times are ET (US) | |
 |
|
|
posted April 08, 2001 04:22 PM