GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 tappering d-bol
|
| Author | Topic: tappering d-bol | ||
|
Cool Novice 
Posts: 22 |
Going to do sust and d-bol, my Q is, should I reduce the dosage ie: 35mg week1, 30mg week2 etc... or keepit at 35mgs aweek? Also proviron, during the entire cycle to help keep hard? or incorparate it last 3 weeks of cycle or leave it out Wiill have clomid and nolva just in case of signs of gyno thank you in advance bro's the dawg    | ||
|
Amateur Bodybuilder 
Posts: 91 |
I usually run at like a cetain dosage for two weeks - go up 5-10mg for another two weeks, then taper for the last two. Hope that helps. rxderrick  | ||
|
Amateur Bodybuilder
Posts: 296 |
I say no taper. I used to Taper, but see better results without and I think you will find that common especially on this board. | ||
|
Cool Novice
Posts: 36 |
TAPERONG SUCKS-SWITCH THE SUS WITH ENANTHATE EVERY FOURTH DAY AND STAY WITH LIKE 40 MILLIGRAMS ED OF DBOLL-AFTER 6 OR 8 WEEKS SWITCH TO EITHER PRIMOBOLAN DEPOT OR EQ EVERY FOURTH DAY> HOPE THIS HELPS> | ||
|
Elite Bodybuilder 
Posts: 875 |
I say: TAPER EVERYTHING It gives your body time to adjust to changes. However, if it has an ester such as deconate, enthanate, iscoparate, etc... the ester will provide the taper after the last injection. Anything that is unbound such as dbol, may require "manual" tapering of the dossages. But hey, in this world, everyone is a ginea pig to some extent. Its your body. After several cycles of experimentation, you can tell us what works best for you and help others draw their conclusions. Until convinced otherwise, I say taper everything.
| ||
|
Elite Bodybuilder
Posts: 819 |
I have to say I don`t care for tapering d-bol either, I keep it steady for 4-5 weeks at 35 mgs. ------------------ |
All times are ET (US) | |
 |
|
|
posted April 07, 2001 08:17 PM