GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 Amp problems..
|
| Author | Topic: Amp problems.. | ||
|
Cool Novice 
Posts: 30 |
How do you guys draw omnadren out of amps? I had serious difficulty last time and only ended up with .6 of a cc in my syringe. I am using 23g 1.5 inch needles. What's the best way to hold and draw? Also, it took serious effort to pull the plunger back as if the thing was pressurized.... thanks...    | ||
|
Elite Bodybuilder 
Posts: 1105 |
pull it back slow and hjust hold it there as you create pressure. It will slowly draw up you should have no problem getting it up just take your time the oils a little thick. This goes fro injecting too bro. Mass Monster  | ||
|
Cool Novice
Posts: 30 |
Thanks... Last time I didn't even realize it but I must have been spillin shit because I only ended up with .6 cc. | ||
|
Pro Bodybuilder 
Posts: 480 |
Yes it's slow, just keep the needle submerged. | ||
|
Novice 
Posts: 9 |
run the amp under hot water for a minute or so . i find it easier to draw then. | ||
|
Olympian 
Posts: 1776 |
AS STATED RUN THE AMP UNDER WARM WATER FOR A MINUTE OR TWO AND THAT WILL THIN THE OIL OUT AND JUST PULL BACK SLOW AND YOU SHOULD GET ALL OF IT. GOOD LUCK M18 ------------------ | ||
|
Olympian
Posts: 1542 |
Use an 18g drawing needle...That's what they're for...Hence the name "drawing needle"! Gets every drop every time. |
All times are ET (US) | |
 |
|
|
posted March 29, 2001 09:25 PM