GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 Anabolic Discussion Board
 bubbles in syringe
|
| Author | Topic: bubbles in syringe |
|
JR Amateur Bodybuilder (Total posts: 79) |
posted April 13, 2000 02:53 PM
  
ok for all you experienced gear lovers. after i pulled out the correct dosage for my shot i tapped the side of the case to make all the bubbles come up to the top. i know you don't want to have bubbles in the syringe but small one's are ok right??? because i had small bubbles at the bottom of the syringe(the side closest to the plunger) and i need to know if this is normal. can i still shoot it. and how do you know if the bubbles are too big too shoot. i followed the procedure's that 2 thick has on his injection site. but i wasn't able to get those little bubbles out from the bottom. even after i let some of the gear run down the pin for lubrication before sticking it. IP: Logged |
|
E2 Moderator (Total posts: 2269) |
posted April 13, 2000 03:04 PM
dont' worry about it , it's an im ijection not iv, you can have some air without worrying about it. IP: Logged |
|
johnny1111 Amateur Bodybuilder (Total posts: 23) |
posted April 13, 2000 03:07 PM
I know it takes approx 3ccs of air in an IV injection to kill a person. A few bubbles in an IM injection is no problem-John IP: Logged |
|
LEGEND Amateur Bodybuilder (Total posts: 20) |
posted April 13, 2000 03:23 PM
i found that if i loaded my pin in the morning and left it point down in my drawer(with the plastic cap on) when i got home from work several hours later, even the small bubbles were gone.......hope that helps IP: Logged |
|
JR Amateur Bodybuilder (Total posts: 79) |
posted April 13, 2000 03:24 PM
good info thanks fellas * strong, like bull* IP: Logged |
All times are ET (US) | |
 |
|
|
