GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 Anabolic Discussion Board
 V problem w/22guage needle??
|
| Author | Topic: V problem w/22guage needle?? |
|
ectomorph Pro Bodybuilder (Total posts: 150) |
posted April 06, 2000 02:31 PM
  
Just started the Jurox V and not only was it hard to draw in, the plunger got stuck twice DURING the injection!! And to top it all off I'm using the BIG 22g inch and a halfers. HELP ------------------ IP: Logged |
|
ectomorph Pro Bodybuilder (Total posts: 150) |
posted April 06, 2000 02:37 PM
bump and a pic of the in question gear.. ------------------ IP: Logged |
|
RAGING BULL Amateur Bodybuilder (Total posts: 59) |
posted April 06, 2000 06:37 PM
Ecto, A couple of ways around this. 1. use the same size pins for the winny as you do for your oil based stuff 2. shake, shake, shake that bottle and the syringe constantly until you inject 3. If the plunger stops halfway in(it happens all the time), just push with a little more pressure--it always goes right in RAGING BULL IP: Logged |
|
chestyII Pro Bodybuilder (Total posts: 496) |
posted April 06, 2000 06:50 PM
Here is a sure fire cure for your troubles. Draw out the v with an 18g. Then put on the 22g. set syringe upside down (needle point to ceiling)do not clear air from needle yet. Let it separate for about 20-30 minutes. Slowly clear air from needle with the clear liquid, quickly invert and inject at a fairly rapid pace. Should cure the problem. ------------------ IP: Logged |
|
ectomorph Pro Bodybuilder (Total posts: 150) |
posted April 07, 2000 02:13 PM
Thanks Chesty,Bull. Tried the extra pressure thing and the shit nearly killed me. J/k. laters ------------------ IP: Logged |
|
gearseeker Amateur Bodybuilder (Total posts: 11) |
posted April 07, 2000 03:05 PM
Hey bro - I use a 21 to draw from the bottle, then shake the piss out of it to make sure its well mixed. Draw some air into the syringe with the pin up to get all of the WV away from the pin. I then put a 25 on, give it another shake, then leave it "pin-up" until Im ready to shoot. After getting the air out, inject quickly. Any pause with the pin down and it will probably jam again. I have great luck with this and its nice to use a 25 instead of a harpoon. One note: I use Stanazol which is very fine. If your Jurox product has large particles (or is fake) it may require a large pin (18-20). Ive seen this with some test sus. products. IP: Logged |
|
macrophage69alpha Moderator (Total posts: 1204) |
posted April 07, 2000 03:35 PM
although you attack my DNP posts I would like to help you out here place the bottle in hot water- for a minute or two-dry bottle-then shake bottle well, draw and inject- you should have not problems then. ------------------ IP: Logged |
|
macrophage69alpha Moderator (Total posts: 1204) |
posted April 07, 2000 03:43 PM
BTW- why not just encapsulate it and take it orally? I see no reason to become a human pin cushion when it is not necessary. ------------------ IP: Logged |
|
ectomorph Pro Bodybuilder (Total posts: 150) |
posted April 10, 2000 11:10 PM
Thanks Mac. You're right a/b the DNP thing.(Me attacking them that is) But I have to agree with you that people are gonna take it anyway and youre helping them to do it safely. Encapsulation works just as well? ------------------ IP: Logged |
All times are ET (US) | |
 |
|
|
