GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 Anabolic Discussion Board
 STANAZOLIC--I am tired of shaking this bottle!
|
| Author | Topic: STANAZOLIC--I am tired of shaking this bottle! |
|
Iean Pro Bodybuilder (Total posts: 133) |
posted April 04, 2000 01:01 AM
  
Ok I have my 20ml. of it. Everything is perfect except the batch # does not match. It is 991044 and expires on OCT. 2002. The box at the top says Ilium but the bottle says produced by Troy. I think that i remember people saying that you have to let it sit still for an hour or two for it to seperate. I do not think it is seperating but I cannot tell for sure because the tint of the glass bottle interferes. is is real? [This message has been edited by Iean (edited April 04, 2000).] IP: Logged |
|
young1 Pro Bodybuilder (Total posts: 113) |
posted April 04, 2000 01:49 AM
If you can't see through the bottle then pull a cc or two into a syringe and see if it seperates there. offcourse shake it before you pull. If it has'nt seperated after over 30 mins (safe time) then it won't seperate ever. Good luck. young1 IP: Logged |
|
Iean Pro Bodybuilder (Total posts: 133) |
posted April 04, 2000 02:35 AM
thanks for the advice, i feel dumb as hell now. it is starting to seperate out. a layer of somewhat discolored substance is settling to the bottom while the milky liquid stays at top. IP: Logged |
|
Iean Pro Bodybuilder (Total posts: 133) |
posted April 04, 2000 02:36 AM
thanks for the advice, i feel dumb as hell now. it is starting to seperate out. a layer of somewhat discolored (not really just different compositino and density) substance is settling to the bottom while the milky liquid stays at top. IP: Logged |
|
macrophage69alpha Moderator (Total posts: 1117) |
posted April 04, 2000 02:44 AM
let it sit over night- there should be a white film on the bottom-sediment. turn the bottle and look at the bottom- it should have white film- then shake well and there should be no white film on the bottom. I do not know what it means that your batch # is not listed on the ausvet site. the batch # should be a sticker ------------------ IP: Logged |
|
Mudworx Amateur Bodybuilder (Total posts: 77) |
posted April 04, 2000 03:56 AM
Troy Laboratories is where Illium's products are manufactured - no need for concern. IP: Logged |
All times are ET (US) | |
 |
|
|