GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 Problems injecting Jurox winny
|
| Author | Topic: Problems injecting Jurox winny | ||
|
Amateur Bodybuilder 
Posts: 72 |
my buddy has been on jurox winny for about 2 weeks. his injections are painful and he has problems injecting, sometimes it wont go thru the pin. he is using 5/8" pins. does anyone else have this problem with jurox winny. thanks peae...Arms     | ||
|
Amateur Bodybuilder
Posts: 101 |
yes thats a common problem with jurox anything less than a 23G pin will not draw easily. better alternatives are ilium stanz, and zam amps. | ||
|
Amateur Bodybuilder
Posts: 82 |
my buddy had the same problem today... he called me and told me that he had a problem and was using a 5/8" 25ga pin on a slin syringe... because the jurox has to be shaken up REALLY good before drawing, it is very possible for the needle to clog... same as with the Jurox Suspension... don't use anything smaller than a 22ga dart... and do not waste much time between drawing it up, and sticking... so it doesn't give the solution a chance to segregate again.. RJ | ||
|
Pro Bodybuilder 
Posts: 482 |
I hate anything bigger than a 25# pin and i just got some of that winny by jurox well I guess i will shake it for 30 minutes before shooting it lol. | ||
|
Olympian 
Posts: 1745 |
shake it hard and put a very small amopunt (hair size) of an oil based in there and it will go right through everytime. | ||
|
Amateur Bodybuilder
Posts: 50 |
Always shake the bottle well, and mix with an oil based juice, then it wont clog anymore ------------------ | ||
|
Amateur Bodybuilder
Posts: 72 |
thanks for all your input guys. i am sure my buddy will appreciate it...Arms | ||
|
Elite Bodybuilder 
Posts: 652 |
Phuck jurox! Zambon forever! I never had a problem injecting it with 29g... ------------------ |
All times are ET (US) | |
 |
posted March 26, 2001 02:34 AM