GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 Anabolic Discussion Board
 Drawing from an ampule
|
| Author | Topic: Drawing from an ampule |
|
Anabolicum Mister Amateur Bodybuilder (Total posts: 19) |
posted March 20, 2000 09:52 PM
  
Quite a bit of discussion on some of the other boards on the correct way to draw from an amp. One fella says you treat it just like a vial - turn it upside down and stick the pin in and draw. Apparently the amp is designed to keep the oil in (surface tension maybe???). I'm going to try it tonight (in about 30 min). If I'm a naive dumbass, please tell me now. Oh well, there's no way to learn like experience. ------------------ IP: Logged |
|
MP5 Amateur Bodybuilder (Total posts: 26) |
posted March 20, 2000 10:02 PM
It does not make sense to me that you would do it that way. I just score it and make sure all the juice is in the bottom part. then snap it, drop in the needle and suck it up. Simple IP: Logged |
|
Anabolicum Mister Amateur Bodybuilder (Total posts: 19) |
posted March 20, 2000 10:29 PM
O.K. Done It freaks you out. You think for sure that the stuff is going to pour out but it doesn't. It's a little harder than drawing from a vial though because there is no rubber stopper for support. Also, toward the end I lost a drop or two - maybe about 1/8 cc. Maybe I didn't do it exactly right. I think I prefer the way I've been doing it - same as MP5. ------------------ IP: Logged |
|
Deepsquat Pro Bodybuilder (Total posts: 408) |
posted March 20, 2000 11:29 PM
Have fun cleaning it up off the floor! IP: Logged |
All times are ET (US) | |
 |
|
|
Powered by:
Ultimate Bulletin Board (UltimateBB), Version 5.42a
� Infopop Corporation (formerly Madrona Park, Inc.), 1998-1999.