GEORGE SPELLWIN'S ANNOUNCEMENTS
UBBFriend: Email This Page to Someone! |
George Spellwin's ELITE FITNESS Discussion Boards
Anabolic Discussion Board injections
|
Author | Topic: injections |
Big Irish Amateur Bodybuilder (Total posts: 19) |
posted March 18, 2000 02:40 PM
How do I stop the gear from leaking back out after I inject.
IP: Logged |
2Thick Pro Bodybuilder (Total posts: 744) |
posted March 18, 2000 02:42 PM
As soon as you take out the needle, you should take a sterile pad and press hard on the injection site and massage the area for a few minutes. Jon ------------------ IP: Logged |
chestyII Pro Bodybuilder (Total posts: 349) |
posted March 18, 2000 02:42 PM
I just put my sterile finger on it and plug the leak. You can also use a gauze pad as well. While holding pressure on it massage it in. ------------------ IP: Logged |
LOWE254 Pro Bodybuilder (Total posts: 110) |
posted March 18, 2000 02:43 PM
Do what I do: Take some toliet paper put some rubbing acholol (spelling?) on it and press and rub on the site hard for about 3-5 min, then slap on a bandaid. If you don't put the dart in deep enoughf then it will fuck shit up so push it in deep, you don't want to waste your gear do ya? ------------------ IP: Logged |
cjac1 Pro Bodybuilder (Total posts: 125) |
posted March 18, 2000 02:43 PM
Try a longer needle. IP: Logged |
WCP Pro Bodybuilder (Total posts: 385) |
posted March 18, 2000 02:48 PM
Yeah, thats what I was wondering..is your pin long enough???? Good Luck Bro, WCP ------------------ IP: Logged |
Big Irish Amateur Bodybuilder (Total posts: 19) |
posted March 18, 2000 02:58 PM
Thanks Bros. Keep the info coming. IP: Logged |
All times are ET (US) | |
Powered by:
Ultimate Bulletin Board (UltimateBB), Version 5.42a
� Infopop Corporation (formerly Madrona Park, Inc.), 1998-1999.