GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 Anabolic Discussion Board
 How do you "safely" use a 50 ML gear bottle
|
| Author | Topic: How do you "safely" use a 50 ML gear bottle |
|
BigBrute Amateur Bodybuilder (Total posts: 51) |
posted March 09, 2000 07:24 PM
 
My experience has always been with amps and redi's, How do I use a 50 ML gear bottle and keep the gear safe and sterile between shots? Do you just stick a pin right through the top of the bottle cap and draw from the same hole every time? or is there a way to actually remove the cap and put it back each time (Doesn't appear as though you can remove the cap at all) IP: Logged |
|
2Thick Pro Bodybuilder (Total posts: 610) |
posted March 09, 2000 07:28 PM
You stick it through the rubber top. You must wipe the top down with an alcohol pad before and after each use. It is recommended that you use one needle to draw the fluid and another to inject because the drawing needle may dull a bit from pushing it through the top of the vial. Jon ------------------ IP: Logged |
|
BigBrute Amateur Bodybuilder (Total posts: 51) |
posted March 09, 2000 07:42 PM
ok, the scored part of the cap pops right off witha knife, leaving the rubber cap exposed. Hope it wasn't too stupid a question.. Brute IP: Logged |
|
2Thick Pro Bodybuilder (Total posts: 610) |
posted March 09, 2000 08:23 PM
Everything must be learned. Nothing just pops into our head from nowhere. It was a very valid question. Jon ------------------ IP: Logged |
All times are ET (US) | |
 |
|
|
Powered by:
Ultimate Bulletin Board (UltimateBB), Version 5.42a
� Infopop Corporation (formerly Madrona Park, Inc.), 1998-1999.