x
Almost there! Please complete this form and click the button below to gain instant access.
EliteFitness.com FREE Email Series: How You Can Use Winstrol, Masteron, HGH, and Testosterone for a Perfect, Muscular Physique!
- -
We hate SPAM and promise to keep your email address safe.
- -


UBBFriend: Email This Page to Someone!
  George Spellwin's ELITE FITNESS Discussion Boards
   Anabolic Discussion Board
  1" pin to small?

Post New Topic  
profile | register | preferences | faq | search

Author Topic:   1" pin to small?
BuffEnuf
Amateur Bodybuilder
(Total posts: 39)
posted February 21, 2000 12:33 PM     Click Here to See the Profile for BuffEnuf   Click Here to Email BuffEnuf     Edit/Delete Message UIN: 63015976
My pins are only 1", is that to short for the glute? I am fairly lean but alot of muscle in the glutes. I am supposed to take another injection in a while, should I goto the delt or thigh, or stay in the rear?

IP: Logged

oversized
Amateur Bodybuilder
(Total posts: 62)
posted February 21, 2000 12:35 PM     Click Here to See the Profile for oversized   Click Here to Email oversized     Edit/Delete Message
i would go to the thigh with that 1 incher

from what i understand u sould stick to atleast a 1.5 for the glute.

oversized

IP: Logged

300 kleen
Pro Bodybuilder
(Total posts: 156)
posted February 21, 2000 01:31 PM     Click Here to See the Profile for 300 kleen   Click Here to Email 300 kleen     Edit/Delete Message
Not a Flame:
You don't seem experienced enough to try a glute injection. The risk of something happening is higher. I would stick to the glute. You are lean, right? No problem...

The only reason a 1.5" pin is perfered is because it's supposed to be in muscle and I'm assuming that you have less than 1" of fat on your ass, so there shouldn't be a problem. Even if you inject into fat the gear will work, but not as potently.

300

IP: Logged

brutus
Amateur Bodybuilder
(Total posts: 4)
posted February 21, 2000 03:14 PM     Click Here to See the Profile for brutus     Edit/Delete Message
I use 1 inch with no problem, just make sure it is all the way in! when you go high and wide with your glute jabs the layer of fat gets even thinner in this region!

IP: Logged

Joe Juicer
Pro Bodybuilder
(Total posts: 159)
posted February 21, 2000 03:19 PM     Click Here to See the Profile for Joe Juicer   Click Here to Email Joe Juicer     Edit/Delete Message
I'm using 1" pins for glute injections right now. It's better to get a 1.5" needle, if you can, but 1" will work fine.

The only issue is that you get a bit leakage with a shorter pin. It pains me to see even a few drops of my drugs get wasted when they leak out of the injection site.

Other than that, 1" is a-ok.

------------------
*** A 23 Gaugue Haiku ***
no more injections
my ass is a pin cushion
take the needle out!

IP: Logged

w8liftr
Amateur Bodybuilder
(Total posts: 78)
posted February 21, 2000 04:03 PM     Click Here to See the Profile for w8liftr   Click Here to Email w8liftr     Edit/Delete Message
1 inch should work, but like Joe said you will get to see some of your juice

IP: Logged

Rock_Man
Pro Bodybuilder
(Total posts: 220)
posted February 21, 2000 04:10 PM     Click Here to See the Profile for Rock_Man   Click Here to Email Rock_Man     Edit/Delete Message UIN: 8696614
If you stretch the skin between your fingures and pull the skin off to the side a little that will deviate the back flow of any juice from a 1" injection at any site. Stick the Glute.

------------------
Rock On!

IP: Logged

All times are ET (US)

Post New Topic  
Hop to:

�2016 EliteFitness.com. All rights reserved.

Powered by: Ultimate Bulletin Board (UltimateBB), Version 5.42a
© Infopop Corporation (formerly Madrona Park, Inc.), 1998-1999.