GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 End of cycle update - do I need Clomid?
|
| Author | Topic: End of cycle update - do I need Clomid? | ||
|
Amateur Bodybuilder 
Posts: 155 |
I have a week left on my cycle, 200mg t200 and 200mg primo per week. Results so far: 157 pounds to 180 pounds (stable). Body fat and water weight actually went down, not up. I dont have any acne, my nuts didnt shrink, sex drive is the same and no signs of gyno. Do I need Clomid? What benefit could I get from it?     | ||
|
Amateur Bodybuilder
Posts: 88 |
No you won't need clomid. Clomid is a waste of money and is useless. You'll be fine. Is this your first cycle? Did you do any research before you started it? Clomid will kick start your natural Test production after you finish your cycle. I always use it and so should you. HCG is helpful too. | ||
|
Amateur Bodybuilder
Posts: 155 |
My cycle was very mellow and my natural test production seems to be fine, I have no side effects. Yes, this is my first cycle. I have clomid on hand, should I use it or not? | ||
|
Freak 
Posts: 1979 |
Yes you should use it, your test was shut down and you will crash without it. It may be a minor crash but a crash none the less. Start taking 100mg/day a few days after your last shot. ------------------ | ||
|
Amateur Bodybuilder
Posts: 155 |
Ulter, 100mgs a day? For how long? Can you give me some more detail please? | ||
|
Freak
Posts: 1979 |
For what you took 14 days is enough. ------------------ | ||
|
Amateur Bodybuilder
Posts: 155 |
These gains are very solid, looks like anyway. I would really like to keep them. What else shoudl I do? Except 100mgs clomid for 14 days. | ||
|
Freak
Posts: 1979 |
That's all folks. ------------------ | ||
|
Pro Bodybuilder 
Posts: 379 |
you could hit HCG four time in the first two weeks post cycle. Mass Monster |
All times are ET (US) | |
 |
|
|
posted February 04, 2001 08:11 PM