There is a way to remove the estradiol from the implant by doing to following: Gather about 2-3 of the pellets together and grind them up with the back of a spoon and make the pellets into as fine of a powder as you can. Then, get 50 ml of diethyl ether (pretty easy to obtain from any chemical supplier) and mix this combination together in a bowl. You then have to let the solution evaporate allowing crystals to form in the bowl. The crystals that form at the top of the bowl contain the estradiol that you are trying to get rid of. You then need to place this solution in the freezer overnight to help aid in most of the estradiol being removed from the testosterone-ether solution. By the next morning, you will pull this solution out of the freezer and the frozen crystallized estradiol will have risen to the top of the bowl (just like bread rising in the oven, he! he!). You then would scrape or scoop the crystals off the top of the solution and get rid of them. The remaining crystal that are left at the bottom of the bowl contain the testosterone propionate that you are trying to get. Then let them air dry for a while to get the majority of the ether off the crystals. You then need to place these crystals in the oven on a low temperature to get rid of any ether that remains for a few hours and you should have left the dry testosterone propionate crystals that you need with a minimum of ether left in them. Make sure you have let them air dry first though. You don't want to blow up the house by putting a bowl of ether in the oven just because you are a little to fucking impatient to get big. Make sure that it is a electric oven as well, you definitely don't want to use a gas oven for this procedure.

After separating the testosterone propionate from the solution, you have two choices for using this compound. One way is to use DMSO (dimethyl sulfoxide) to make the steroid transdermal meaning that it will now pass through the skin. There are a variety of forms that DMSO is available but the gel version works the best and is the easiest to use. What you want to do is grind up the crystals to as fine of a powder as you can and then mix it with one teaspoonful of DMSO and one of water and apply to the skin every 2-3 days as that is the effective time span for testosterone propionate. You can then rub this compound into your skin and wrap the area with a piece of saran wrap to help get the compound to absorb into the skin easier since it will heat it between the saran wrap and your body to aid in absorption.

The other way to take this compound is through injection. You can do this by mixing the compound with about 2 cc of oil or sterile water and injecting it that way. Even grinding up the particles as fine as you can you will have to use about an 18 gauge needle to inject this concoction. I would suggest using the DMSO method above to do this.
good to stack with winny ref test prop and tren ect.