GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 Newbie question on needle size
|
| Author | Topic: Newbie question on needle size | ||
|
Novice 
Posts: 2 |
What's up everybody! I just stumbled into this wonderful board. I need your help figuring out what needle size I need to inject. You see I have a flat butt and since there's not much meat down there I'm confused as to what size of needle I need to inject. I'm 27 years old 5'6 178 pounds.     | ||
|
Elite Bodybuilder 
Posts: 896 |
glutes-23G 1.5'' | ||
|
Elite Bodybuilder
Posts: 670 |
A 1" or 1 1/4" may be sufficient if you are skinny. The deeper the better though. | ||
|
Cool Novice 
Posts: 37 |
flatt butt round butt no butt, doesn't really matter. 25 and 27 are too thin for oil injects and dont go deep enough. 23's good like rainhorn said. 21 is 'unnecessary' | ||
|
Amateur Bodybuilder 
Posts: 103 |
right on rainhorn 23g 1.5's ------------------ | ||
|
Amateur Bodybuilder
Posts: 188 |
23g 1.5 needle length for oil-27g .5 inch for water based. ------------------ | ||
|
Moderator 
Posts: 1601 |
you are new so i would like to welcome you i would also like to tell you about this great feature we have here it is called the SEARCH function it can answer most of the simple questions that are asked here by new guys welcome! ------------------ | ||
|
Amateur Bodybuilder
Posts: 85 |
So you can use 27g 1/2 inch to pump Winstrol into your quads? | ||
|
Pro Bodybuilder 
Posts: 593 |
You didn't mention what you were shooting? Deca? B True | ||
|
Novice
Posts: 2 |
I'm going to use primobolan and laurabolin. | ||
|
Elite Bodybuilder
Posts: 1064 |
I use a 25g for all my oil injections. 1.5" for glutes and 1" for quads and delts. 22,23 and 25g are all fine. | ||
|
Freak 
Posts: 1669 |
25 for any oil roid (heated a bit in hot water). Insulin needle for waterbased roids if microrefined, which are the best. 1 inch for the butt, unless you have too much fat. ------------------ Don't look back, life is too short | ||
|
Pro Bodybuilder
Posts: 366 |
Bro, go to the top of this page and hit the featured sites link. Then go to 2thick's needle site. It should answer all of your questions. Welcome to the boards. ------------------ | ||
|
Elite Bodybuilder
Posts: 1339 |
Well bro, I started off using 23 gauge 1 1/2" pins for everything...BAD IDEA...but was recently told that I can get away with 25g, 1" pins, and some other posts back that up... ------------------ |
All times are ET (US) | |
 |
|
|
posted January 12, 2001 11:47 AM