GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 Transfering Redi-jects to a new syringe
|
| Author | Topic: Transfering Redi-jects to a new syringe | ||
|
Amateur Bodybuilder 
Posts: 215 |
OK, I've done this several times before, but each time I transfer the sust to the fresh syringe, I always end up with much less than 1cc...looks like around .85cc's. Where did the rest of it go? Also, what is the best way to transfer. I know there are a couple of ways to do this. But is one better than the other? I prefer to pull the stopper off the new syringe, and just squirt the sust right into the new syringe case. Is this better than sucking it out of the rediject with the new syringe? One thing I noticed, is that a little of sust leaks out of the new syringe after making the transfer. Please help...i dont want to waste anymore juice.     | ||
|
Guru 
Posts: 4106 |
Just change the Needle | ||
|
Amateur Bodybuilder
Posts: 215 |
The sust redijects I have don't come with needles. And I don't think a standard disposible needle fits on the redijects. | ||
|
Guru
Posts: 4106 |
Allways worked for me. | ||
|
Elite Bodybuilder 
Posts: 665 |
Just use the 18guage whalehooks you baby! JK  Maybe if you have a leftover empty vial you could put the shot in there & then draw it out again with the fresh pin. | ||
|
Elite Bodybuilder
Posts: 665 |
Or you could squirt the shot into a spoon & suck it up with the pin to be used like a big fat shot of SMACK.. | ||
|
Amateur Bodybuilder
Posts: 215 |
BigJay: Are you saying that a standard needle will fit on the rediject syringe? I heard that they tend to fall out or get loose or something like that. Can you confirm they work for you? | ||
|
Guru
Posts: 4106 |
I have used BD and Terumo needles on them and worked fine. Just make sure its tight like it should be in the first place. |
All times are ET (US) | |
 |
|
|
posted January 02, 2001 02:31 AM