GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 Raw powder to injectable/orals
|
| Author | Topic: Raw powder to injectable/orals | ||
|
Cool Novice 
Posts: 27 |
Looking for info on how to take raw powder anabolic steroid and measure it to take orally and how to make your own injectable.What type of oil is best to mix with powder? Where can you buy the vials and crimpers? What is the best way to take orally? Capsules? How do you measure correctly? D bol, anadrol, winstrol, and deca powders would be used.If you have any experience or info please post. TJ [This message has been edited by t_jillich (edited December 31, 2000).]     | ||
|
Cool Novice
Posts: 27 |
bump | ||
|
Novice 
Posts: 8 |
If you take 200ml of Propylene Glycol and dump 5g of powdered d-bol in it you get 25mg/ml. Just like Reforvit B. For Winny, if you take 100ml of bottled water and dump in 5g you get a 50mg/ml concentration. This one doesn't dissolve, so you have to shake it real good each time before you dose it. This is not steril, so don't use for injections. The math for the rest of the stuff you want to mix stays the same. If you are going to do injectables, look around for a kit. Lots of those around. Good luck. |
All times are ET (US) | |
 |
|
|
posted December 31, 2000 05:54 PM