Dilute T400 with sterile grapeseed oil

[MaxxReps]

Hey everyone,

After my current cycle, I am planning on cruising for a bit on some T400 that I have (150mg enanth, 150mg cyp, 100mg prop). Planning on 200mg / week.

Thing is, thats .25ml twice a week and all I have are 3ml terumo syringes. I want to dilute the gear so I'm injecting 1ml. - easier to measure, less waste and less pain from the t.prop.

I have a 50ml sterile vial, and 50ml of sterile grapeseed oil. The T400 is in Ethyl Oleate. I was going to use a 10ml syringe to move 7.5ml of the T400 into the sterile vial, move 22.5ml of the grapeseed oil into the same vial, and 7.5ml of the grapeseeed oil into the T400 vial.

Before I do something dumb and waste my T400 (or worse) wanted to run it by you guys.

 

[Mh48500]

I dont see a problem as long as you are moving seterile to sterile. Usually in this case you would attach a filter before transferring it, but if your oil is sterile then you should be GTG. I personally never had reduced pain from Prop by thinning it out. I am not sure why but I had better luck heating the syringe in a glass of hot water.

Good luck!

 

[MaxxReps]

Thanks brother.

Not as worried about pip as measuring and dosing .25ml in a 3ml syringe but reduced pain would be a bonus. I could probably find 1ml syringes somewhere but just have tons of 3ml's.

I was mostly concerned with mixing EO with grapeseed oil.

 

[AnonCanada]

That should work. Just out of curiosity, why are you running such a low dose? ,